 |
IK ratings are defined as IKXX, where "XX" is a number from 00 to 10 indicating the degrees of protection provided by enclosures (including luminaires) against external mechanical impacts. The different IK ratings relate to the ability of an enclosure to resist impact energy levels measured in ... Read More
|
| |
COUNTRIES AND STANDARDS COUNTRY STANDARD Argentina IRAM 2063: 2009 Ed 4.0 Australia AS/NZS 3112 Denmark IEC 60884-1 + 107-2-DI Finland IEC 60884-1 + SFS 5610 France IEC 60884-1 + N FC 61-314 Germany IEC 60884-1 + DIN VDE 0620-1 India IEC 60884-1 + IS 1293 Irish Republic IS 401 New Zealand AS/NZS ... Read More
|
| |
IP rating comprises of a two-digit number e.g. IP54 where the first digit represents the ingress of dust as detailed in the top table below second digit represents the degree of protection against water as detailed in the bottom table below Table Detailing The Protection Against The Ingress Of Dust ... Read More
|
| |
The IEC has established an enclosure grading system that produces an IP rating. (For example, IP 54 - "5" is the first character - refer to tables I & II. "4" is the second character - refer to table III - following page). Table I - Degrees of Protection against Hazardous Parts Degree of protection ... Read More
|
| |
www.nema.org NEMA National Electrical Manufacturers' Association 1300 North 17th Street Rosslyn, VA 22209 NEMA Standards Publication No. 250 enclosures for Electrical Equipment (1000 Maximum) NEMA Standards Publication No. ICS6 enclosures for Industrial Controls and Systems www.ul.com UL Underwriter... Read More
|
| |
Related gauges for E27 caps: 1. Go gauge for E27 caps on finished lamps, code 7006-27B-1; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of caps on finished lamps shown on sheet 7006-21. Testing: When the cap on a finished lamp has been screwed into the gauge ... Read More
|
| |
Related gauges for GX53 caps: 1. Go and not go gauge for caps GX53, 7006-142-1; Purpose: To check caps GX53-.. in the following respects: - the diameter of the individual pins (dimension A); - the combined displacement and diameter of the pins (dimension A and D); - the length of the pins (dimension ... Read More
|
| |
Related gauges for B22d caps: 1. Acceptance gauge for B22d caps intended for automatic wire threading, 7006-3-1; Purpose: To check the suitability of automatic wire threading of B22d caps as shown on sheet 7004-10. Testing: The cap shall be assumed to be correct if can be inserted smoothly into the ... Read More
|
| |
Related gauges for E40 caps: 1. Go gauge for caps on finished lamps E40, 7006-27-7; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E40 caps on finished lamps. Testing: When the cap on a finished lamp has been screwed into the gauge as far as it will go, the ... Read More
|
| |
Related gauges for E26 caps: 1. Go gauges for caps E26, E26/50x39, E26/51x39 & E26d, 7006-27D-3; Purpose: To check the maximum dimensions of the screw thread and dimension T1 minimum of E26, E26/50x39, E26/51x39 or E26d caps on finished lamps. Testing: When the cap on a finished lamp has been ... Read More
|
